300kg automatic welding turning plate
The positioner is a special welding auxiliary equipment, suitable for welding displacement of rotary work, to obtain the ideal machining position and welding speed. It can be used with the operation machine and welding machine to form an automatic welding center, and can also be used for manual work. Firstly, according to the maximum rotation speed of the table, the motor of the same power, the speed reducer of the Tongguang reducer, the lower the maximum speed, the larger the torque, the smoother the rotation; to check whether the use of the welder current, the rotary conduction of the positioner can meets the requirements;the motor control choice, you can choose DC voltage speed regulation, AC frequency control, stepping or servo numerical control speed regulation, etc., according to the need of the machine intermediate through hole. Finally, select the chuck fixture and the gun rack according to actual needs.
Product Description
300kg automatic welding turning plate
Model: BWJ-300
Input power:AC220V 50/60HZ
Capacity:0°/90° 300Kg / 150Kg
Work bench diameter:500mm
Optional chuck：XH400
Blessing range：30-500mm
Work bench middle diameter:90/140/170mm
Work bench height:650mm
Work bench turning speed:0.2-2.5rpm
Returning angel:0~90°
Turning ways:manual
Turning power:200w
Out size:590(L)×610(W)650(H) mm
Net weight:120kg
Before using the welding positioner, make sure that the plugs are connected correctly and reliably, and the grounding wire is connected to the ground reliably to avoid equipment damage.
1. Turn on the power and turn on the power switch “POWER” and the power indicator will light.
2. Under the “FOOT” control state, the foot switch is pressed, the table rotates, the foot switch is released, and the table stops rotating; in the “AUTO” control state, the machine enters the automatic control or time control state.
3. Turn the direction switch to “→”, the table rotates clockwise; dial “←” and the table rotates counterclockwise.
4. Rotate the speed adjustment knob “SPEED” to change the table speed, rotate clockwise, and speed up; counterclockwise rotation, slow down.
5. Time control function: This function can realize the automatic operation function of the positioner within a preset period.
The specific operation method is as follows:
Turn on the power, preset a working cycle (in three states, "H" means "hour" is the counting unit, "M" means "minute" is the counting unit, "S" means "second" is the counting unit), Turn on the “POWER” switch, the power indicator light is on, and the worktable will automatically stop working after one cycle of rotation;
6. Welder interface function: This function can realize the linkage between the welder and the positioner.
